10 product(s) found for "Misc. Parts and Tools"

Replacement switch insert for the C6, S4 and stainless steel host tail cap assembly. The switch can be removed and installed using fine needle-nose pliers or a bent piece of wire to span the two holes in the switch face.

This is the same driver 'pill' and brass ring that is included with our DIY host assemblies, but with the pill drilled through with a .630" (16mm) diameter opening. Perfect for use with our P/M SL-BBCB Blank Battery Contact Board and rectangular shaped driver circuits. Fits the C6 and our S4™ and stainless steel hosts. Designed for 16.8mm...

A replacement bezel o-ring for the S4 host assembly. This Buna-N o-ring is 24mm outside diameter x 1.5mm thick.

Replacement glass lens for the Survival Laser tactical flashlights, or for your own build. Lens is 0.905" (23mm) in diameter, outer edge is ground smooth. Fits the Survival Laser S4 and stainless steel host assemblies.

Replacement polished aluminum reflector for the Survival Laser tactical flashlights, or for your own build. Fits the Survival Laser S4 and stainless steel host assemblies.

Survival Laser 1,000 lumen 5-mode diode and driver pill assembly using the high-performance  Cree XM-L T6 emitter . Modes are high, medium, low, strobe and SOS. Emitter is rated at 1,200 lumens (manufacturer estimate on high mode). Uses a single 3.7 volt 18650 battery (only). Estimated total run time in high mode is 1 hour. Fits the Survival Laser...

Replacement 3-48 x 1/8" long alloy steel set screw used in the Survival Laser heat sinks.

Replacement 0.050" x 1-3/4" long Allen wrench for tightening the 3-48 set screw used in the Survival Laser heat sinks.

MADE IN USA. Self-centering diode press for 5.6mm diodes is made from carbon steel for long lifetime usage. Comes with a brass sleeve that screws onto the threaded portion of AixiZ-style diode modules. The press is drilled with a hole all the way through so that any leads soldered onto the diode won't have to be removed.

This is the driver "pill" and brass ring that is included with our DIY host assemblies. Fits the C6 and our S4™ and stainless steel hosts. Designed for 16.8mm diameter round driver boards. Note: Driver circuit not included.