MADE IN USA.
This is the famous BlitzBuck™ adjustable driver made popular on LPF! This latest V5 revision has been updated from the V3 version with a lower part count, more heatsinking space, higher efficiency, less ripple, minimal to no input spike and now includes silicone insulated lead wires. Specifications:
Diameter: 16.84mm +/- .05mm
Input Voltage: 1.2*Vin - 16V
Output Voltage: <1V - 9V
Output Current: 1.5A - 3A (varies slightly per board)
Ripple Current: <100mA
Input Spike Current: <100mA
Circuit Continuity: Isolated D- and D+ Features:
- Thermal shutdown. Will protect your driver (and diode) in the event of driver overheating. Once it reaches the temperature threshold, it will shut down until the main IC drops to a sufficiently low temperature to restart again. However, if left on, it will decrease in temperature, turn on again, and then turn off again due to temperature increase. This will lead to a pulsed effect on the output. This indicates it needs some rest time.
- Soft-start. There is a 1ms soft-start built into the driver to prevent large inrush current spike.
- Open-circuit protection. No current will be drawn and no current will be outputted when the test load or diode is disconnected from the output. It will not damage the driver whatsoever leaving it like this for any amount of time.
- Adjustable. 3mm potentiometer for allowing smooth control over the current output. Note:
Pill and brass ring not included, must be purchased separately. Click here
for a specification sheet and user's guide.